給料機應按規定的安裝方法安裝在固定的基礎上。移動式給料機正式運行前應將輪子用三角木楔住或用制動器剎住。以免工作中發生走動，有多臺給料機平行作業時，機與機之間，機與墻之間應有一米的通道。
給料機使用前須檢查各運轉部分、膠帶搭扣和承載裝置是否正常，防護設備是否齊全。膠帶的漲緊度須在啟動前調整到合適的程度。
皮帶給料機應空載啟動。等運轉正常后方可入料。禁止先入料后開車。
有數臺給料機串聯運行時，應從卸料端開始，順序起動。全部正常運轉后，方可入料。
運行中出現膠帶跑偏現象時，應停車調整，不得勉強使用，以免磨損邊緣和增加負荷。
工作環境及被送物料溫度不得高于50℃和低于-10℃。不得輸送具有酸堿性油類和有機溶劑成份的物料。
輸送帶上禁止行人或乘人。
停車前必須先停止入料，等皮帶上存料卸盡方可停車。
給料機電動機必須絕緣良好。移動
The feeder should be required for the installation method to install on a regular basis. Mobile feeder wheels should be before the official run using triangular wedge or with a brake check. So that move, the parallel operation of a plurality of feeder and between machine and machine, between the machine and the wall should be one metre of the channel.
給料機使用前須檢查各運轉部分、膠帶搭扣和承載裝置是否正常，防護設備是否齊全。膠帶的漲緊度須在啟動前調整到合適的程度。
The feeder shall inspect all machinery, belt buckle, and the bearing device is normal before use, protective equipment are complete. The tightness of the belt should be adjusted to the appropriate level before the start.
皮帶給料機應空載啟動。等運轉正常后方可入料。禁止先入料后開車。
The belt feeder should be no-load start. And other normal operation can be entered into the rear. Prohibition of driving after the first entry.
有數臺給料機串聯運行時，應從卸料端開始，順序起動。全部正常運轉后，方可入料。
A plurality of feeder series operation, starting from the discharge end, sequential start. After all normal operation, can be entered into the material.
運行中出現膠帶跑偏現象時，應停車調整，不得勉強使用，以免磨損邊緣和增加負荷。
Belt deviation occurs during the operation, the parking should be adjusted, shall not be reluctant to use, to avoid edge wear and increase the load.
工作環境及被送物料溫度不得高于50℃和低于-10℃。不得輸送具有酸堿性油類和有機溶劑成份的物料。
The working environment and the material temperature of the material are not higher than 50 and lower than -10. Shall not be transported with the acid base oil and organic solvent ingredients.
輸送帶上禁止行人或乘人。
The conveyor belt is prohibited from pedestrians or passengers.
停車前必須先停止入料，等皮帶上存料卸盡方可停車。
Parking must be stopped before entering the material, and other belt feeding and unloading to stop.
給料機電動機必須絕緣良好。移動式給料機電纜不要亂拉和拖動。電動機要可靠接地。
The motor must be well insulated feeder. Mobile feeder cables don't pull and drag. Motor to reliable grounding.
皮帶打滑時嚴禁用手去拉動皮帶，以免發生事故。
When the belt is slippery, it is forbidden to use the hand to pull the belt, so as to avoid the accident.
式給料機電纜不要亂拉和拖動。電動機要可靠接地。
皮帶打滑時嚴禁用手去拉動皮帶，以免發生事故。
|
