一级做a爰片丝袜A片-国产超级特黄Av-一级黄片。。。。。。。。视频-男女三级全黄视频-亚洲一级毛片免费在线观看-一级a免一级a免做免费线看内裤-中国一级黄色视频免费看-亚洲第一久久三级毛片-a免费黄色a片一级

影響尖溜槽分選的參數有：
   （1）物料預選準備   不需預選分級，存在有粘土質時，除去0.04毫米粒級，進行脫泥。
   （2）粒度大小及比重差   顆粒尺寸小于4毫米，分選礦物的比重差不低于1克/厘米³。當兩種礦物比重的比值大于1.7時，分選條件最佳。
   （3）給料濃度  一般在45～60%（重量百分濃度）范圍內。
   （4）溜槽尺寸  適宜長度介于0.9～1.2米；槽壁的張角為8～12°。
   （5）槽的傾角  傾角必須大于顆粒開始沉積在槽底時的臨界角1～2°。
   （6）效率   實踐表明單個槽子最適宜的處理量為0.6～1.5噸/時。

The influence parameters of tip chute separation:
(1) the material is not required to be pre selected for the qualification of the material, and there is a sticky soil in the presence of a 0.04 mm grain grade, which is carried out in the mud.
(2) the size of the particle size and the proportion of the difference of the particle size is less than 4 mm, the proportion of the separation of the mineral is not less than 1 g / cm 3. When the ratio of the two mineral proportion is more than 1.7, the separation condition is the best.
(3) feeding concentration is generally within the range of 45 to 60% (weight percent concentration).
(4) the size of a suitable length between 0.9 ~ 1.2 meters chute; the slot wall angle is 8 to 12 degrees.
(5) the dip angle of the groove must be greater than the critical angle of the particle at the bottom of the groove 1 to 2 degrees.
(6) the efficiency of practice indicates that an optimum amount of single tank is 0.6 ~ 1.5 tons / hour.